Performance - Ford Focus MK2 (2004-2010)

Focus RS MK2 Group A Cold Air Feed which is designed to work with all Group A Open filters. Supplies a cold air feed directly into the Group A Filter Improving and maximising the airflow and performance. The cold air feed comes with Cold feed guide which sits just below the filter securing the trunking as well as a front grill-mounted plate which replaces the original plastic piece. Each kit comes with a 780mm piece of ducting, required plates and all required bolts and fixings. Please select options below of the kit you require. Option 1: Engine Bay Base Plate with Air Duct Option 2: Engine Bay Base Plate, Front Grill Plate & Air Duct   PLEASE NOTE: Silver finish is for illustrative purposes only.

Read more less

State of art polymer laminated glass cloth Superb heat barrier qualities Withstands radiant temperatures up to 450°C/850°F Ultra thin for minimal clearance As used in WRC and F1 Each roll is 50mm wide x 5 metres long (2" x 16ft) Adhesive backing for ease of fitting After extensive market research Forge Motorsport are proud to release a state of the art metalized polymer laminated glass cloth with adhesive backing that is both extremely light and capable of handling continuous radiant temperatures of up to 450°C. It reflects up to 80% of all radiant heat, whilst offering weight savings against other heat reflecting materials. Forge Motorsport's gold reflective heat barrier requires minimal clearance and is an extremely pliable material with a pressure sensitive adhesive backing that is easy to apply and remove. As used in WRC and F1, make no mistake this gold reflective heat barrier tape is of excellent quality and superb value for money. When used correctly this tape can be used to protect intake components thus lowering IATs resulting in a more efficient and reliable engine cycle. Typical uses are: Wrapping wiring, inside engine covers, bulkheads and firewalls, boost pipes, fuel lines, under seats, intake pipes, airboxes, engine compartments, fuel cells…  

Read more less

  After being very popular for other ford models, AutoSpecialists are pleased to announce their Bonnet spacer kit for Focus Mk2 including RS & ST The spacers raise the rear of the bonnet up by 23mm and can be fitted within 30 minutes with special inverted bolts. HOW DO THEY FIT? Lift the bonnet up and put a soft cloth under the bottom corner of the bonnet and then one side at a time remove the 2 x 10mm bolts attaching the bonnet hinge to the bonnet, discard the old bolts and install the billet spacer block and use new inverted bolts to secure. It's that easy! A great low cost way to change the look of your Focus and release high under bonnet temperatures for Fast Road or Track use -complete kit 2 x Billet spacers and complete with stainless fixings

Read more less